Ask Experts Questions for FREE Help !
Ask
    Wookie's Avatar
    Wookie Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2007, 09:28 PM
    Fan Malfunction
    Recently installed 3 speed, ceiling fan with light worked properly for about 6 weeks. Now fan only works on one speed and slows when light is turned on. What might be causing the malfunctioning?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 12, 2007, 05:48 AM
    Recheck all the wiring you did. Look for a loose wire.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Nov 12, 2007, 08:40 AM
    Does it have remote control or work with switches?
    ceilingfanrepair's Avatar
    ceilingfanrepair Posts: 5,733, Reputation: 109
    Uber Member
    		  
    #4

    Nov 13, 2007, 03:00 PM
    I second labman's question.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ceiling fan malfunction [ 9 Answers ]

I had a Casa Vieja Probe II ceiling fan (w/light; no pullchain) installed about two years ago. It has a wireless remote for fan and light operation, and when I had it installed the electrician connected it to a wall switch so I could also turn it on/off at that location without using the remote....

My PC malfunction [ 2 Answers ]

Why is it that when I use my PC my computer says vga no signal?? Wats does vga mean?? :confused:

Generator Malfunction [ 3 Answers ]

I recently inherited a Honda EX1000 portable generator. I got it running quite well after cleaning out the carb. However I just discovered that it's outputting way more voltage then it should be (good thing I only burned out a light bulb). The measured voltage across the main outlet is approx....

Furnace malfunction [ 8 Answers ]

I have an old (14 years ?) York Stellar furnace that used to have this problem sometimes. When the gas was released over the red glowing electric igniter, it would ignite with a more or less loud pop that would also kill the flames. Then it would go again through the whole sequence and everything...

Furnace malfunction [ 2 Answers ]

Why would my furnace kick off and say limited cycle on the code ?on a coleman evcon

View more questions Search