Ask Experts Questions for FREE Help !
Ask
    DarkCloud's Avatar
    DarkCloud Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 28, 2007, 05:19 PM
    Goodman furnace will not start
    Newer goodman furnace will not start on call for heat... well 1 out of 15 times it will. The little fan turns on , the HSI glows , gas valve clicks after HSI goes out. This is LP. Can Anyone help?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Oct 28, 2007, 07:35 PM
    Is there gas,, could it be turned off
    DarkCloud's Avatar
    DarkCloud Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 29, 2007, 01:05 PM
    NO the gas is not turned off
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #4

    Oct 29, 2007, 02:30 PM
    There is a safety pressure switch located close to the gas valve to shut it off in case of low gas pressure, this switch is only installed on propane furnaces. Check you gas pressure with a manometer, the proper pressure will be on the data tag on the furnace. Good luck, Mike
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Goodman Furnace - brand new - won't start [ 7 Answers ]

Installed this summer, A/C works fine. First time I started the furnace (last week) it started fine, then shut off shortly (15 min. later). No led errors are reading on the board. After shutting off power to re-start the start sequence (it shuts down after 3 tries), the inducer motor starts,...

Goodman furnace [ 5 Answers ]

The furnace comes on and the furnace ignites. It then burns for a few seconds and goes off without the fan coming on. I have changed the flame sensor. Didn't help. Also the fan will come on by itself without the furnace coming on. Help!!

Goodman Furnace will not start [ 4 Answers ]

I have a new Goodman 80% natuaral gas furnace, GMH80451ANA. After installed, it fired right up and ran for about 30 minutes and burned off the smell from the exchanger tubes. Ran it a second time for another half hour or so, then it would not fire up again. The only thing I did was to change...

Goodman furnace [ 17 Answers ]

I have a goodman furnace. Forced air. No a/c. I turn the power on and she starts. Thermostat is off. No wires are crossed that are visible. The pilot does not ignite but the heating element is on. No gas seems to be coming through. Any suggestions? The furnace is only a year and a half old.

View more questions Search