Ask Experts Questions for FREE Help !
Ask
    DSMITH83's Avatar
    DSMITH83 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 12, 2007, 12:02 PM
    Furnace Reseting over and over
    I have a white Rogers system that When turned on doesn't cycle up and turn on It starts for about 1-2 seconds then resets over and over I have tried cleaning the flame rod and also change Thermastat and ignitor. Any idea what would cause this?
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
     
    #2

    Oct 12, 2007, 04:58 PM
    Sounds like possibility an ignition control modual.
    Do you have a good blue flame or is it yellow?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #3

    Oct 12, 2007, 06:56 PM
    Make sure you have a good equipment ground on the ignition control box and on some systems the gas valve has to have a good ground to the equipment also. Or if the flame sensor (the metal rod part) is touching the burners or any other metal it won't work. Make sure flame sensor wire has not grounded out to equipment also.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Reseting temperatures on a honeywell central air system [ 1 Answers ]

I have a honeywell Central air system and cannot seem to get the air to flow through the vents

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...


View more questions Search