Not your question?
  Ask your question
  View similar questions
   
  
 Add your answer here.Check out some similar questions!
Make boiler
 [ 8 Answers ]
 I want to take a Jenny steam pressure washer and convert it to a boiler I can use for my pipe lining. I am a licenced Master Plumber. (43 year) I did boilers for 15 Years. I want to regulate the heater to 7-10 lbs. of pressure put a circulator on it and circulate hot water into my liner. Also the... 
Boiler question
 [ 10 Answers ]
 I live in the state of NY. Does anyone know if it is code to have a low level cutoff when installing a boiler? I am not sure exactly what that is or where it would be installed but I wanted to make sure. I had an estimate by a company and they don't seem like they are going to do this unless I want... 
Boiler keeps fusing
 [ 3 Answers ]
 I have a combi boiler which has been going great it cut out yesterday and then the digital display and power went off. I spotted the blown fuse which I have replaced but it keeps fusing any ideas? 
Boiler issues
 [ 2 Answers ]
 I have a water boiler with an external pump and an internal transformer as my heating source, controlled by a Honeywell programmable thermostat. The PROBLEM: #1. When I turn on my heat, the PUMP will NOT START sometimes! At times, it WILL START and run! Sometimes it will start but cycle off after... 
Boiler replacement
 [ 3 Answers ]
 
I live in Chicago in a 2300 sq ft ranch. The home was built in 1955, and has the original boiler, which was converted from oil to natural gas. Although the boiler is working fine, I wonder about replacing it as the cost of natural gas keeps going up. The efficiency of the new boilers must be far... View more questions Search 
  |