Ask Experts Questions for FREE Help !
Ask
    jumartinez's Avatar
    jumartinez Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 30, 2007, 03:26 PM
    GE Washer won't complete spin cycle
    I bought my washer used. It works fine, until it gets to the spin cycle. It starts to drain, and after a few minutes it will begin to spin and stops. However, if it has no clothes in the tub, it will complete the spin cycle. Once in a while, it will complete the cycle with clothes in it, but it is very rare. I opened up the front panel and there were no oil leaks. The belt looks new and is tight. The inside is very clean. What could I do to fix it or will I have to take it in to be repaired? :confused:
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Sep 30, 2007, 03:54 PM
    You are sure the belt is good? If so,the basket is attached directly to the transmission, which itself spins during the spin cycle. The retaining nut could be loose. You would have to remove the agitator and basket to verify this. To me GE/Hotpoint are the most aggrivating to service.If you are handy and have patience, you should be able to repai ryourself
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Spin cycle on Kenmore washer [ 1 Answers ]

There is a broken switch on the underside of my Kenmore washer preventing the spin cycle from working. How hard is this going to be to fix?

Whirlpool washer gets stuck before spin cycle [ 2 Answers ]

My Whirlpool model LST7233AQO gets stuck before it goes to the spin cycle. It doesn't happen every time, but it's happening more and more. For a while, I was able to get it to continue by depressing the lid switch by sticking a spoon handle in the slot where the lid tab goes in. Now, even that...

Whirlpool Washer Spin Cycle [ 1 Answers ]

Just bought a new whirlpool washer (MD#: WTW5790SQ0), the spin cycle on the washer doesn't work on any cycle EXCEPT normal wash. This was determined by: closing the lid, selecting each individual spin option on the dial and pulling the knob out (starts washer). Both spin cycles work on the Normal...

Kenmore washer wobbles during spin cycle [ 4 Answers ]

I acquired a used Kenmore 110-91552210. Don't know how old it is. During the spin cycle it vibrates and sounds off balance, does not walk. Doesn't seem to be effected by the size of the load. Can anyone help?

Kenmore Washer Won't Complete Spin Cycle [ 0 Answers ]

Hi, I have a Kenmore 110.4549290 that will agitate, and even will spin up to and including the start of the rinse cycle. It then drains the first rinse water, puts in a couple cups of water, but does not go into the rest of the spin cycle. The timer can be heard running (quietly), and it shuts...

View more questions Search