Cycle starting after a D&C

comet79 Posts: 1, Reputation: 1

New Member

Sep 17, 2007, 03:55 PM

Cycle starting after a D&C

I had a D&C done a couple weeks ago. I was wondering if it is possible that I have started my cycle already. I had bleeding after the procedure which stopped four days later. Then nothing until another 7 days past that which resembled my normal period.

Check out some similar questions!

Kenmore Dryer - heats & runs but stops mid-cycle [ 12 Answers ]

I have been trying to figure out what exactly is up with our Kenmore dryer. We bought it new in 1997 and it has run like a champ till now. It still heats up and the drum still tumbles. In the regular drying cycle - you set the timer for 60 minutes and about 15 minutes into the cycle, the dryer...

B&S 14HP Model 287707 slow crank starting [ 4 Answers ]

I have a 1992 MTD 1442 riding mower with a B&S 14HP OHV engine MOdel 287707 Type 0153 01 Code 9210214A. It hasn't been starting except with the use of a charger/starter. Engine wouldn't crank but when charger/starter put on it, could get engine started. Now even the charger/starter won't start...

A/C & Heat Cycle to long [ 2 Answers ]

My A/C & heat system continues to run way after the Thermostat has reached the set temperature. I have a digital thermostat. I replaced the thermostat thinking that was the problem, but the new one does the same thing. Any ideas or reasons... This only began 4 days ago. Otherwise no problems at all...

A/C & Heat won't Cycle. Why? [ 1 Answers ]

I have a Trane Central A/C & Heat Unit. My Unit just started continually running, Won't cycle on & off. I can adjust the temp and it shuts off fine. Also comes on perfectly. Heats & Cools Fine. But won't cycle back off automatically afterwards! Replaced the thermostat and it still does the same...

View more questions Search

Check out some similar questions!

Add your answer here.