 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Must play with drain hose to get washer to drain and spin
Hi, I have a GE WCSE6270 Washer. After the washer fills and agitates, it starts to make a gurgling, clicking noise and will not finish the cycle (i.e. drain and spin). I noticed that the drain hose in the back was a little leaky, and in trying to play with it, it made the washer drain and spin correctly. I have done a few loads since, and it gets stuck at the same place in the cycle, and the only way for me to get it to work, is to play with the hose. The hose doesn't look kinked, but I do notice that the seal is not good against the washer, and it still leaks somewhat. Can a leaky drain hose connection cause it to lose suction and thus stop it from draining and spinning? Thanks for any help, Robert.
|
||||
|
||||
|
This is a new one to me. A faulty lid switch will cause it to stop like you say. I'm wondering if you have a bad or loose wire on lid switch and the movement ot the hose causes the wire or connection to make contact. Maybe the same with the contacts in the timer. Check those items and see if the problem is there. Post back with results. I'm interested in the outcome of this. Good Luck
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My drain hose was cracked bad after twenty years and I replaced it with one I purchased at Home Depot. The original one was longer, but I bought this one anyway. The original was drapped over the hanger and then through the opening in the back cover and then hooked into the drain (which is...
We just moved into a house with a septic system and a basement hook-up for the washing machine. There is a open pipe above the washer hookups which I assume is the drain for the washer? How do I change out the hose or do I add an extension or what? Or is this a job for a plumber? It's a...
Where can I go to get one, mine doesn't come wioth one since its used. One hose is small and the other dopubles it right. The one on the wall is much larger than the one on the machine
I need to get my new dish washer (I haven't brought yet), to a drain. The problem is that (My 4 plex is commercial and all concrete) the closest drain is 10' away from center. I'd even like to get it to drain in the G.disposal, which is another 4 feet, which makes it 14' total. Is this possible? Is...
View more questions Search
|
