Ask Experts Questions for FREE Help !
Ask
    toddscor's Avatar
    toddscor Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jan 25, 2007, 10:32 PM
    Drain hose on washer
    Where can I go to get one, mine doesn't come wioth one since its used. One hose is small and the other dopubles it right. The one on the wall is much larger than the one on the machine
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #2

    Jan 26, 2007, 04:20 AM
    As I said in your other question, usually the drain hose is part of the washer. The best thing may be to check with the dealer or an appliance parts place, and buy a replacement for the original. It should all be one piece starting at the pump, then a fitting to hold it in place where it goes out the cabinet and up to a hook to go in the pipe in the wall.

    I don't understand about the other one. Usually they just have 1. Usually you can go to a place like Lowe's and look what the hoses are like on the new ones. Lowe's also have hose and tubing in their plumbing department you might be able to make work.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How far for the dish washer drain hose? [ 1 Answers ]

I need to get my new dish washer (I haven't brought yet), to a drain. The problem is that (My 4 plex is commercial and all concrete) the closest drain is 10' away from center. I'd even like to get it to drain in the G.disposal, which is another 4 feet, which makes it 14' total. Is this possible? Is...

Leaking drain hose [ 1 Answers ]

My drain hose that is attached to the washer and drains into the wall is leaking at the connection from the washer. How do you tighten the clamp? Is it possible I need to get a new clamp? So far I have cleaned up 2inch standing water 3 times in my laundry room. Each time I think I have it tight...

Washer hose rusted on [ 1 Answers ]

My brother in law just bought an old house, from the 50's. As they were installing the new washer they noticed the old cold water hose was rusted on to the vavle. After numerous attempts with WD40 two pipe wrenches and two guys the thing still has not budged. In an attempt to possibly screw off...

Washer hose flow valve [ 3 Answers ]

I just bought new washing machine connectors at a national home improvement store. They are billed as flood preventative because they have a diaphram valve at the connector which shuts down water flow when flow exceeds 2.5 gpm. However, I can only turn on the water valves less than a quarter of a...

Hose Pipe Drain - Not There [ 5 Answers ]

I just moved into my first home. It's a new construction. I have connected my dryer, even replaced the cord because it was the wrong prongs. Now my washer has 3 tubes. I have connected the hot and cold, but there is no place for the drain pipe. Was this suppose to be in the house when it was built?...

View more questions Search