Ask Experts Questions for FREE Help !
Ask
    scruffy's Avatar
    scruffy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 20, 2007, 06:10 AM
    Dyer shutting off
    I have a ge dryer mo no. dvlr223etoww it shuts off after about 5 min and when I leave it set it will start and run though the cycle
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Jul 20, 2007, 06:40 AM
    I'm leading toward the timer. Does it do it with all temperatures? If this unit has a humidity sensor , they get gummy and can be scrubbed with 409, or alcohol. Also with units with humidity control the thermostsats will have 3 leads on them. 2 for temp and 1 goes to the timer motor. If the stat is bad and opening up it will stop dryer from running. Then as it cools down it closes and sends power back to timer motor. Could be one of the sensor is not operating properly. These stats are not expensive and woukd be a good place to start. Good Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool Dyer Won't Start and Interior Light Won't Come On [ 1 Answers ]

I saw other posts regarding Whirlpool dryers that wouldn't start and the suggestions of checking the door connection, but in our case 1) there are no exterior lights, and 2) the interior light doesn't come on. Any suggestions are greatly appreciated. Thanks, Ben

Kenmore dyer with no heat [ 1 Answers ]

I have a kenmore dyer series 110 Serial #ms4002505 Runnning but io have no heat Circuit breaker checked and is okay.. lint removed... is it possible I need a new heating element as I have had it approimately 2years Tks [email protected]

Gas dyer problem [ 1 Answers ]

-------------------------------------------------------------------------------- Hi I am an HVAC tech an having problems with my Frigidaire gas dyer M#GLGR331AS2, S#XD31100005. Here it goes, it runs for about 5 to 10 minutes. Then cycles off, the flame. When it goes to relite the HSI warms up...

Dyer Not Drying [ 3 Answers ]

I put the hose to the dryer and the other end that is attached to the house. I made sure it was secure. Once today the dryer was not even warm and I checked that hose and it had popped off. I replaced it. Now my close are drying, but at a slow rate and the hand dial thing is not moving closer to...

View more questions Search