Ask Experts Questions for FREE Help !
Ask
    Pomazon's Avatar
    Pomazon Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 15, 2007, 02:19 PM
    Whirlpool Gold Catalyst Washer
    This was our FIRST Whirlpool washer/dryer set and our LAST!! How does one remove the control panel?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Jul 15, 2007, 02:45 PM
    Should be 2 screw at front corners and then just lift. Possible they could be hidden under a piece of crome that has to be removed first.
    Pomazon's Avatar
    Pomazon Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jul 15, 2007, 04:04 PM
    Quote Originally Posted by Pomazon
    This was our FIRST Whirlpool washer/dryer set and our LAST!!!!!!!!!!!!!! How does one remove the control panel?
    Removed the control panel, been dealing with inoperative agitator, spin/drain cycles, F3. F4 fault codes, checked lid switch continuity, o.k. manufacturer recommends replacing control board; sound reasonable?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #4

    Jul 15, 2007, 04:11 PM
    It could be. If it is not agitating/spinning I would look at the coupling. It is located between the motor and transmission and not too difficult to do. However, I am not familiar with the F3&F4 code. I believe I would check the coupling first as if it is bad only about $15. The board would be a whole lot more.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool Gold Catalyst Washer problem [ 15 Answers ]

Hi My model number is GSX9885JQ0 The washer will fill with water but doesn't agitate. The light on the control panel blinks instead of being on solid. It doesn't display an error code on the panel, just shows how much time is left. I also tried unplugging and letting it reset. I also tried using...

Myt Whirlpool Gold will not spin [ 2 Answers ]

Hello all, We have a whirlpool gold catalist mod: GSX9885JQO and it will NOT spin. It will go through a complete cycle without any error codes. It just won't spin. HELP.

Whirlpool Gold Catalyst washer error message [ 6 Answers ]

Whirlpool Gold Catalyst washer stops running and displays an error code of F3 or F4.

Whirlpool Gold washer motor problems [ 1 Answers ]

I have a Whirlpool washer GSX9885JQ0 that burnt the motor and cap too. Is this a common problem. Is there a way to check the control board to see if that was the problem or is it one of those things that I need to replace the motor and if that burns up then next time I should replace the board...

View more questions Search