Ask Me Help Desk

Ask Me Help Desk (https://www.askmehelpdesk.com/forum.php)
-   Appliances (https://www.askmehelpdesk.com/forumdisplay.php?f=157)
-   -   Whirlpool Gold Catalyst Washer (https://www.askmehelpdesk.com/showthread.php?t=110186)

  • Jul 15, 2007, 02:19 PM
    Pomazon
    Whirlpool Gold Catalyst Washer
    This was our FIRST Whirlpool washer/dryer set and our LAST!! How does one remove the control panel?
  • Jul 15, 2007, 02:45 PM
    esquire1
    Should be 2 screw at front corners and then just lift. Possible they could be hidden under a piece of crome that has to be removed first.
  • Jul 15, 2007, 04:04 PM
    Pomazon
    Quote:
    Originally Posted by Pomazon
    This was our FIRST Whirlpool washer/dryer set and our LAST!!!!!!!!!!!!!! How does one remove the control panel?
    Removed the control panel, been dealing with inoperative agitator, spin/drain cycles, F3. F4 fault codes, checked lid switch continuity, o.k. manufacturer recommends replacing control board; sound reasonable?
  • Jul 15, 2007, 04:11 PM
    esquire1
    It could be. If it is not agitating/spinning I would look at the coupling. It is located between the motor and transmission and not too difficult to do. However, I am not familiar with the F3&F4 code. I believe I would check the coupling first as if it is bad only about $15. The board would be a whole lot more.

    • All times are GMT -7. The time now is 10:27 PM.