Ask Experts Questions for FREE Help !
Ask
    Zenio's Avatar
    Zenio Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 8, 2007, 07:26 AM
    Goodman furnace fan speed
    How do I change the fan speed on a Goodman Dependable Ninety Two furnace.
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Jul 8, 2007, 07:36 AM
    Red wire is low blue is med and black is high. Look at fan motor and see which wire is connected and disconnect it and wire in the speed you want. Should be high speed for A/C
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Changing furnace fan speed to change delta [ 7 Answers ]

I have a 12 year old Goodman furnace. About 3 years ago, I asked a service tech if there was anything that can be done to get warmer air out of the registers. He said he slowed the blower speed to get a higher temperature rise. I had the ductwork replaced and it is smaller than the original...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Air conditioner, blower fan speed with carrier furnace [ 2 Answers ]

The fan speed does not adjust when the air conditioner is on . Is this normal ? If I turn the set temp up high enough the air conditioner turns off and the adjustability returns. Auto, low, medium and high all work. When I set the temperature back down so the air conditioner turns back on the...

Furnace slow speed fan [ 1 Answers ]

For the EXPERTS I have a Goodman GMS8 furnace with air. The manual slow speed fan setting was never hooked up at the thermostat. I believe it is just a matter of jumpering the terminals to engage the slow speed fan. If this is correct what terminals (at the furnace) do I jumper on the circuit...

3 speed ceiling fan only has 1 speed [ 3 Answers ]

I have a 3 speed Hunter ceiling that I rarely turn off and all 3 speeds had been working. I recently turned it off and when I turned it back on, only the high speed is working. I assumed the switch was bad and replaced it. I still only have the High speed. Has anyone had this problem before? ...

View more questions Search