Ask Experts Questions for FREE Help !
Ask
    annicoco's Avatar
    annicoco Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 5, 2007, 06:12 AM
    Can I replace glass for pilot light window?
    We have an older Coleman wall Natural Gas heater. The glass is missing where you can look at the pilot light (some foil has been stuck in there). Is there a certain type of glass we can put in there? We are selling our house and the inspector said to replace it.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Jul 5, 2007, 05:18 PM
    Quote Originally Posted by annicoco
    We have an older Coleman wall Natural Gas heater. The glass is missing where you can look at the pilot light (some foil has been stuck in there). Is there a certain type of glass we can put in there? We are selling our house and the inspector said to replace it.
    Check With your local HVAC company to find the part or call Coleman/Evcon with your model and serial number and tell them your looking for a sight glass for this heater. You may even check the parts side of Coleman/Evcons web site. Good luck.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

91 Civic 2 dr Hatchback WINDOW GLASS [ 1 Answers ]

Hellp folks.. Before I start, I likd that notion too much.. sombody misses me at last!. :cool: So back to the business...

Repairing broken glass block window [ 1 Answers ]

How do I repair / replace a broken glass block in a glass block window? It is right in the middle of the window. The window appears to have a rubber gasket between each block. Thanks.

Dryer vent through glass block window [ 2 Answers ]

Hello everyone, I'm obviously new here and hope to find help. I have a client who wants me to run a dryer vent through a glass block window. Can I cut a 4-1/16" hole in it without shattering or cracking? Or how can I remove 1 block of glass? Thanks

Re-route vent below window to install sliding glass door [ 1 Answers ]

I want to install a sliding glass door off the back of my house. It would be best to put it where I currently have a window. Only one problem, there is a vent centered directly below the window. Correct me if I am wrong, I have two options 1.) Move the vent off to the side of the sliding...

View more questions Search