Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
94 civic hatchback cranks but doesn't start
[ 2 Answers ]
The car cranks over really strong, has spark, fuel, and compression although on the 1st cylinder the compression is lower by 50 psi, and the rest are at like 180psi. I was thinking that it might be the timing, but I'm not sure, sometimes it seems like it's going to start then it just goes back to...
Repairing broken glass block window
[ 1 Answers ]
How do I repair / replace a broken glass block in a glass block window? It is right in the middle of the window. The window appears to have a rubber gasket between each block. Thanks.
Dryer vent through glass block window
[ 2 Answers ]
Hello everyone, I'm obviously new here and hope to find help. I have a client who wants me to run a dryer vent through a glass block window. Can I cut a 4-1/16" hole in it without shattering or cracking? Or how can I remove 1 block of glass? Thanks
1990 honda civic hatchback...
[ 3 Answers ]
all right so this is how it all began... I bought this civic... it ran fine for about three days... then every time I would come to a stop it would sputter and then idle normal again... then it just died when I came to a stop... I waited about 15 minutes and it started back up then sputtered and...
Re-route vent below window to install sliding glass door
[ 1 Answers ]
I want to install a sliding glass door off the back of my house. It would be best to put it where I currently have a window. Only one problem, there is a vent centered directly below the window. Correct me if I am wrong, I have two options 1.) Move the vent off to the side of the sliding... View more questions Search
|