Ask Experts Questions for FREE Help !
Ask
    kprattjr's Avatar
    kprattjr Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 11, 2007, 06:05 PM
    TempStar Eff. Rating
    We have a TempStar Gas Furnace Model Number NUGK075DG06 (867) (769425). I can't find the information on the furnace efficiency for this model. Any ideas or where I can find the information. Its an older furnace so the tempstar site didn't have it listed anywhere I was able to find it. Thanks
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jun 12, 2007, 12:50 PM
    If it has a metal flue pipe it is probably 70%
    If it has a plastic/PVC pipe for the flue it is 90%

    I could not find the model number but it is a good model number.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New $6,000 tempstar won't work [ 51 Answers ]

I have just purchased a new Tempstar 4 ton 13 seer, 78 afeu 1410A refrigerant. Model # PGX 348080K01A1. I had this thing installed in January, the heater worked fine. The ac won't work right. The guy that installed it has been here 5 times. He is at a loss as to what the problem is. The air...

Tempstar Furnace [ 2 Answers ]

I have a gas Tempstar furnace , The pilot ignites but the furnace does not it tries a few times then stops. The blower works . What might the problem be?

Tempstar furnace [ 6 Answers ]

I have an 80+ tempstar with the smartvalve gas valve. During the call for heat, the inducer motor starts, but the ignitor will not come on and light. I checked the ignitor and it is good. I checked for voltage and it is good. Could the gas valve be bad, since the ignitor is controlled by the valve...

New Installation Goodman GMS 91155 DXA eff 93% [ 1 Answers ]

HI My Goodman furnace will not (repeat cycle) . Furnace will operate, but after it reaches The desired HEATING TEMP, it shuts down and will not recyle, when the temp drops. I then get the 3 blink flashing light---indicating (pressure switch is stuck open). Then I turn the furnace off for...

Electrical outlet rating vs. Circuit breaker amperage rating [ 5 Answers ]

Hello to all, I am new to this forum, please excuse me if this question has been answered. I just bought a Thermal Dynamics Plasma cutter. It has a Nema 50-P plug end on it, which I assume is to be plugged into a Nema 50-R outlet. In looking in my reference book, this is a 3 wire...


View more questions Search