Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Gas furnace - no flame
[ 4 Answers ]
Hope someone out there can help, because it's going to get cold this weekend! I have a split HVAC unit with furnace in attic. Written on front of unit is Intertherm. Inside panel of unit says Nordyne, and the Ignition Control is Robert Shaw. The unit is 13 years old and the heat worked fine...
Maytag Neptune Gas Dryer Flame Not Present
[ 1 Answers ]
Our Maytag Neptune Gas Dryer MOD: MDG3000AWW, S/N: 13282488UU, does not dry on either heat setting (normal; perm press). Thanks to earlier discussions on this site, I learned to check the igniter, which I've found does not glow. What should I do next? Never mind - I pulled the igniter out and...
Gas dryer trouble with flame
[ 1 Answers ]
My Kenmore gas dryer takes 2 or 3 cycles to do what it used to in 1 cycle. Observing the flame, it runs about 45 seconds then cuts off even with a full wet load. It will cycle back on then shut off again after running about 45 seconds. I suspect that either the thermal limiter, wherever that is, is...
Orange Flame Gas Appliances Make Me Blue
[ 2 Answers ]
All burners on stove are burning with an orange flame. The heater and water heater also have an orange flame. Could there be a problem with the gas service into the house, possibly a meter problem ? Everything was fine and suddenly all went bad ? Thanks, KFMT
Gas Stove Flame is yellow
[ 1 Answers ]
My gas stove flame recently is more yellow than blue and is not as efficient when cooking. I am wondering if I need a new gas stove or if it is the gas. Does anyone have any insight on this? Thanks, Sharon View more questions Search
|