Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Reduced water pressure after installing new water heater
[ 8 Answers ]
Quick history: 1. House is about 85 yrs old, two kitchens, two baths, and a laundry room sink near the water heater. Visible water main into the house is copper, however, after the water filter unit (with no filter element) is another foot of copper connected to galvanized piping. 2. Last...
Water pressure died after installing new diverter
[ 3 Answers ]
I recently installed new reccessed bathroom shower from kohler. It has single lever diverter. Water is diverted to shower by using knob on spout. After installing it, I found out that water pressure in spout and shower has decreaed by large amount. I can't say if its water pressure or water...
Installing a water softner slab
[ 5 Answers ]
I am considering installing a water softener for my home which is on a slab. Is it likely that the main comes to an accessible location within the house (i.e. to the hot water heater) before going to the other locations, or is it likely that from the meter or in the yard there is a tee with one leg...
Replacment of geyser element
[ 1 Answers ]
When unsrewing the old element it became tandled to such an extent that it is impossible to get it out. What should I do? Can I unscrew the six or seven nuts taking off the plate from the geyser into which the element fits?
No water from sink after installing dishwasher
[ 1 Answers ]
I live in a house that was built in the early 1900s so the piping is really old and I didn't want to chance breaking anything so I went the cheap way out and I didn't sodder anything. I took the hose off from my hot water and added a T pipe that screws on to where the hose used to be. Left side... View more questions Search
|