Ask Experts Questions for FREE Help !
Ask
    banjosnr's Avatar
    banjosnr Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 27, 2010, 03:53 PM
    L100 John Deere won't start after removing and replacing the deck
    My L100 tractor was working fine but after I removed the deck to replace a spindle and blades I believed I had replaced everything back where it belonged but when I went to start it I got no response. There is no clicking or starter turning or anything.
    I checked all the wires, the fuse and everything else I could see but nothing jumped out and told me the problem. My initial thought is the seat sensor but I have no idea how to check it. I can find it, unplug it and put it back but that's it.
    Any help would be appreciated.
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #2

    Sep 27, 2010, 07:01 PM

    Check your lever that engages the pto /mower deck make sure its all the way off.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Sep 27, 2010, 07:15 PM

    Sure it could be the seat sensor (safety switch) but it is far more likely to be something you didn't quite get right in reassembly. Start with DGs suggestion.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

John Deere L100 Deck belt assembly [ 2 Answers ]

I'm looking for diagram of john deere l100 deck belt assembly. Please help.

John deere l100 won't start but does turn over? [ 1 Answers ]

Cheked power at seat kill switch while cranking had 0 volts. Checked fuel filter its OK. Checked fues its OK. Changed spark plug. Don't know if getting spark.

John deere won't start [ 1 Answers ]

John Deere X304 starts but almost immediately cuts off as if it ran out of gas I changed the fuel filter but results are the same. Problem started after I ran out of gas and refilled the tank with newly purchased gas.

Have a john deere L100 no start [ 2 Answers ]

John deere L100,NO START,took off starterand had it checked and its fine. I HAVE 12 VOLTS AT THE BATTERYand 12 volts going into the senolid but no volt coming out of the other side of the senolid and no volts at the starter.CAN I jump the starter senolid like the old FORDS or will it short the...

John Deere L110 won't start [ 1 Answers ]

Hi, I am having trouble cranking my John Deere L110. It was running fine then in the middle of mowing I had to stop and when I tried to restart I was hearing a clicking sound when the key was turned. I read a response on this site to a similar problem and tried what was recommended. I have replaced...

View more questions Search