Ask Experts Questions for FREE Help !
Ask
    naynay7579's Avatar
    naynay7579 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 14, 2012, 06:46 AM
    The Phlanders Flange Co. has been doing quite well lately and would like to accelerat
    Assume you are the CFO of Phlanders Flange Company and discuss in a substantial way the issues you might have with Harry's proposal. Remember, Harry is your boss (the CEO), so be professional and tactful in your writing!

    At a minimum, your memo to Harry should address the following items:
    - Do Harry's calculations over- or undervalue Framingham, and what are the potential consequences?
    - A discussion of value assessments in mergers.
    - How the long-term growth rate of the target affects premium to be paid for the target's stock.
    - Effects of synergies and bias.
    - Your recommendation of what additional steps Harry should take before making the offer and why.

Check out some similar questions!

My 1999 honda accord 130 thous mile sounds like a motorcycle in idle n when accelerat [ 1 Answers ]

Honda 1999 accord 4 cylinder. 130, 000 miles. Idles loud like motorcycle. When press gass pedals makes same motorcycle sound

Hole in floor is larger than closet flange, and the flange may be too low [ 3 Answers ]

We recently put down ceramic tile in one of our bathrooms. A friend of ours did the job for almost nothing, as he had most of the required supplies left over from another job, including tile. Now there is water leaking from the base of the toilet. After scouring the DIY sites on the internet, I...

Flange bolts broke off in cast iron flange [ 7 Answers ]

After laying tile in a bathroom, we tried to remove two flange bolts from a cast iron flange, but the both broke off flush with the flange. They were too short to begin with, but now we can't even get them out. It's as if they're rusted in. What can we do?

Cast iron toilet flange the bolt holes will not hold how do we fix it and the flange [ 1 Answers ]

We have a cast iron flange and the bolt holes are not useable can we cut off the top and add a new plastic flange


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.