|
|
|
|
New Member
|
|
May 24, 2006, 05:05 PM
|
|
Problems with laminate flooring
Before I go back to the place that installed my laminate floors, I need to know if there is something I can do. It is so hard to set up a time with them to come back out. There are a few planks that are slightly up at the corners and do not lay flat. When I swiffer, it snags. I have tried beating the corners down with a rubber mallot but that does no good. Also, I hate the way it sounds when I walk across it with heels or hard shoes. I really did not want to pay so much for more area rugs. Does anyone have these concerns? I really welcome as many answers as possible from those of you that got fairly cheaper laminate so I can live with what might have been a bad decision. I am on a tight budget. I have 1400 square feet of this stuff, but it does look good.
|
|
|
Uber Member
|
|
May 24, 2006, 05:18 PM
|
|
Looks like they didn't leave the 1/4" necessary under the baseboards to make it a floating floor. It sounds like they butted the laminate right up against the wall and it's buckling. Only fix is to remove the baseboards, lift the laminate panel and take off some material. There are members with more experience than me around here so you should wait for a second opinion, though I just installed a floor a few months ago so that's fresh in my mind.
|
|
|
Senior Member
|
|
May 24, 2006, 05:40 PM
|
|
What more than likely happened was when they connected the boards together it was not fully square with the next piece on the end edge. Check along the long edges of the floor boards to make sure they are all tight in the areas you mentioned. If there are slight gaps along the lengths, the ends won't connect totally square to each other and when they slam them together to close the end gaps what happens is a corner will lift.
There is no really easy solution if the boards are in the "field" of the floor. One possibility would be get a razor knife, straight edge and cut the high edges until they lay flat, touch up w/ a wax stick and use clear nail polish so the ends don't delaminate.
If the edges are lifted close to the walls, the problem may be what Needkarma said.
|
|
|
Uber Member
|
|
May 25, 2006, 03:06 AM
|
|
Both good suggestions to look at.
As for the sound, you are hearing pretty much how laminate sounds. When I did mine I used a thicker heavier pad than the basic one and it's not too bad... but I still had to get used to it.
Beyond looking at the above, I'd definitely get the contractor back out there.
It could even be that there is a piece of something on the floor under where it's coming up... or those pieces could be damaged where you can't see it.
Either way, if it's not laying flat, then it's due to incorrect/poor installation.
|
|
|
New Member
|
|
Dec 10, 2008, 06:30 PM
|
|
Comment on NeedKarma's post
It make sense
|
|
|
New Member
|
|
Jan 23, 2012, 12:56 PM
|
|
How is it best to cut boards to fit on doorways with lots of little angles
|
|
|
New Member
|
|
Feb 6, 2012, 10:42 AM
|
|
I have a blackfilm after my flors are clean make our feet black I just use warm water should I use vinager and alcohol with warm water so I can walk on my floors and bottoms of my feet are clean and not black
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Laminate Wood Flooring
[ 5 Answers ]
My husband just recently installed laminate wood flooring throughout the house. Can someone please recommend how to clean these floors? Some people have said just spray a little water and damp mop. Can it be cleaned with any kind of cleaner? I just bought some Murphy's Oil for wood floors but on...
Laminate flooring problems
[ 2 Answers ]
Have you ever heard about using a t-bar when installing laminate flooring. We just remodeled and had the floor professionally installed . Some spots seem to be rippling. The had an inspector come in and verified the installation is good,level,there is a 1/4 in gap around perimeter. It's a top of...
Laying laminate flooring
[ 3 Answers ]
I'm in the process of laying laminate flooring in a bathroom and need to cut the laminate to fit around the base of the toilet and the basin pedestal. Is there any gadgets that you can buy to help create a template? Alternatively, has anyone got any advice on how this can best be achieved. I'm...
Question about laminate flooring, using 2 diff kinds
[ 6 Answers ]
Currently our house has a Victorian style laminate floor in the Kitchen. The kitchen floor meets the carpet of the living room in a doorway.
I was was wondering if anyone has used a different type of laminate flooring where it would meet with another room of a different pattern? The kitchen...
Laminate floor
[ 1 Answers ]
I'm installing a pergo product over a vinyl kitchen floor, do I need to remove the vinyl to the wood sub-floor? Or can I install right on to the vinyl? Also do I have to use an underlayment since the kitchen is over the basement, no sound or moisture issues? I have been advised by both ways on this...
View more questions
Search
|