Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Connecting basement plumbing to cast iron waste stack
[ 1 Answers ]
I'm putting in a half bath and a washing machine in our basement and I'd like to like to connect it to the main stack and drain, which is all 4-inch cast iron. The sweep where the stack meets the sewer line has no clean out and appears to have some corrosion, so I'd like to replace it. I was...
Exterior Cast Iron Waste Stack
[ 2 Answers ]
I have an old house where the soil stack (4" cast iron hub) was installed on the exterior wall out side of the house. At the second floor level there is a sanitary "Y" into the house second story bath. Above this "Y" the cast iron reduces to 2" cast iron vent but does not extend to the roof and...
Cast Iron Vent Stack
[ 2 Answers ]
I have just purchased a 1950's rental property with a cast iron vent stack. The insurance co. wants me to replace it as they are prone to leaking in older homes. The job seems fairly straight forward, but do you have to replace the elbow/cleanout at the bottom that is cemented into the basement...
Cast iron waste
[ 1 Answers ]
Removing toilet from cast iron waste
Cast iron vent stack
[ 7 Answers ]
I'm installiing a new basement bathroom and when running a vent stack I would like to tap into the existing cast iron with PVC using a saddle on the cast. My question is what method is used to cut a hole in the cast iron, where I wish to place the saddle and connect the PVC. View more questions Search
|