Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Basement Plumbing
[ 9 Answers ]
Hello, Im starting to finish my basement and have a few questions on the stubbed in plumbing. It is stubbed for a full bath and drains into an ejector pump. I marked on the photos below what I thought each pipe is for, but there is one unknown 2" pipe next to the toilet. Also, on the other...
Backwater valve for finished basement
[ 3 Answers ]
Tom, I currently finishing my basement and have heard/read that if the flood rim level of any fixtures is below the next upstream sewer manhole cover that a backwater valve should be installed to prevent sewage backup into the finished basement in the event there was a main sewer line block or...
Basement plumbing
[ 1 Answers ]
I have a basement I want to finish were the plumbing is roughed in. They have 4 drain pipes in a row. One is 3 inches, two are two inches and one is one and a half inch. I figure one is for a shower , one is for a sink one is for the toilet, but what is the one and a half inch pipe for?
Basement plumbing
[ 1 Answers ]
I want to install a shower, toilette and hand basin in the basement. I don't have a roughed in basement so I need an answer to a drain question. I have a sump pump in one corner and an ejector pump in the other corner close to the furnase. At the furnase there's a drainpipe connected to the drain...
Basement Plumbing
[ 1 Answers ]
I'm presently trying to finish a bathroom in a basement that was started by a previous home owner, and want to move the shower location. The drainage is roughed into the concrete slab. There is a 4" (toilet drain), and two 2" drains (sink and shower). I want to move the shower location to where... View more questions Search
|