Ask Experts Questions for FREE Help !
Ask
    ennaD's Avatar
    ennaD Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 26, 2012, 05:15 PM
    Clutch problems
    My 2004 Honda civic clutch won't engage in all gears. Stick shift feels loose fluid levels are OK car was working fine this morning
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Aug 26, 2012, 05:28 PM
    If you are having trouble getting into gear, make sure the hydraulic clutch reservoir is full and bled. If the throwout arm moves fully, you may need a new clutch and pressure plate.
    ennaD's Avatar
    ennaD Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Aug 26, 2012, 05:32 PM
    Clutch problems
    How do you bleed clutch? Clutch Pendle feels fine. Won't engage into gears proprly.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #4

    Aug 27, 2012, 09:20 AM
    It may be a worn clutch or you have air in the system. I use a one-man brake bleeder to bleed the hydraulic clutch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

94 ford escort 1.9l clutch problems [ 18 Answers ]

Several months ago the clutch was replaced, and it has been driving fine ever since yesterday when the car did not want to go into any gear, I turned it off and back on and it went in to all the gears for like 30 seconds, then once I shifted out it would not go back in, what is most likely the...

Electric pto clutch problems [ 1 Answers ]

1994 Troybilt Gtx 18 Model 13060. I need a pto clutch part # 1744401 which is no longer made. Looking for a electric pto clutch 4 1/2" double pulley, 1/2 belt,1 1/8" shaft, 3 15/16" height that I can attach to a made metal plate which can be mounted to the motor. The original clutch manufacturer is...

Troy Built electric clutch problems [ 1 Answers ]

I have a Big Red Troy built. Factory clutch burned out. Melted wiring on clutch to the point that plastic ran down into clutch and fused it together. Two other clutches have been put on this mower and the same thing has happened. Didn't even make it around the yard till each one burned up. To...

Problems with my clutch [ 2 Answers ]

I am hearing what seems to be my throw out bearing and the transmission is hard to put in gear. Could it be the throw out bearing or the slave cylinder? Or the throw out bearing holder?

View more questions Search