Not your question?
Ask your question
View similar questions
Check out some similar questions!
Furnace blower can not auto start
[ 29 Answers ]
I have a problem with my furnace blower not starting automatically. It works good when I swiched the fan option to "ON", the furnace was burning and fan was running. However if I pick "AUTO", only the furnace burns periodicaly, and the fan totall gets stuck. I am wondering if it is a wiring...
Furnace Manual Fan OK - Not Auto Though
[ 1 Answers ]
I have a York Stellar Plus (15yrs old) with an Auto and Manual Fan Switch on the T-stat. The Fan will work when turned to ON (at the T-Stat) but it will not come on when you turn the heat on with the Fan switch turned to Auto. I have replaced the Limit Switch. No difference Thanks!
Central Air works intermittently
[ 6 Answers ]
We have relatively new house. The central air was installed in 2001/2002. This is OUR first time using it. First thing I realized was the circuit breaker for the condenser and fan was bad, so I replaced that. The unit ran fine for a few days. Then we shut it off for a few days. When we...
Auto sprinkler - works yesterday, not today?
[ 1 Answers ]
:confused: I finally programmed my sprinkler system correctly and it worked yesterday afternoon - went through all six zones with no problem. This morning it did not start. The controller was going through the zones, but the pump never started. We had wasps move into our pump start relay last...
Furnace won't heat in Auto
[ 2 Answers ]
I have read the different posting and replys, but they don't seem to address my problem. Friend has an older Kenmore Power Miser 70 that has an old electronic ign. (no flame senser). The furnace will heat when the fan switch is set to "on" position, and it will cycle the heat. When the fan is... View more questions Search
|