Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Goodman GMNT, noise and blower speed
[ 4 Answers ]
I have a GMNT 120-5, the vent motor is extremely noisy during operations and can be heard in the entire house. Any possibility to repair or should I just replace the motor? After a recent service call the technicians switched the blower speed to a higher level which due to the high velocity now...
Janitrol Furnace issue motor would not start and pressure switch stuck closed
[ 4 Answers ]
Hi I got this Janitrol Furnace it worked fine. Until my basement flooded then it looks like the circuit board got wet and it was on at the time. So basically I ordered a new board suppose to be coming soon. What happened was when the furnace came on like there were no flames only a bright...
Goodman furnace will not start
[ 3 Answers ]
Newer goodman furnace will not start on call for heat... well 1 out of 15 times it will. The little fan turns on , the HSI glows , gas valve clicks after HSI goes out. This is LP. Can Anyone help?
Goodman GMNT main switch error
[ 2 Answers ]
It's Easter morning... and it's colder than Christmas morning... and my 5-year new Goodman GMNT furnace is not working. Getting 4 blink code, main / auxiliary switch error. I have turned unit on and off and have it working, however when it shuts down and I think the blower continues to run causing...
Bryant Furnace won't start flame on my emergency generator
[ 4 Answers ]
My newer Bryant plus 80 T gas furnace would not start the flame when it was connected to my emergency generator during an ice storm that caused the commercial power to go out. Is this a result of the poor power quality of the emergency generator which messed up the electronic circuits of the... View more questions Search
|