Ask Experts Questions for FREE Help !
Ask
Page 2 of 2 « First < 2
    runwest50's Avatar
    runwest50 Posts: 12, Reputation: 1
    New Member
    		  
    #21

    Nov 24, 2009, 01:20 PM

    It came w/kit but I don't think I need to change any wiring.
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #22

    Nov 24, 2009, 01:25 PM
    Quote Originally Posted by runwest50 View Post
    I don't think I need to change any wiring.
    If the old one works but the new one doesn't, apparently you do. I cannot help you if you are unwilling to follow my directions. Good luck.
    runwest50's Avatar
    runwest50 Posts: 12, Reputation: 1
    New Member
    		  
    #23

    Nov 24, 2009, 01:28 PM

    Sorry I don't understand. I did not see any additional steps to install this in my Bryant. I must be wrong.
    Product # 398AAW036080AFJA
    Thank You
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #24

    Nov 24, 2009, 03:46 PM
    The kit should have included these items, along with the instructions (see previous attachment). Notice the bundled red lead wire in the package. It provides an additional control circuit that the previous board may not have used or required.
    Attached Images
     
    runwest50's Avatar
    runwest50 Posts: 12, Reputation: 1
    New Member
    		  
    #25

    Nov 24, 2009, 08:04 PM

    Thanks
Not your question? Ask your question View similar questions
 
Page 2 of 2 « First < 2

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant furnace won't start, error 42 [ 9 Answers ]

Hi all, I have a Bryant furnace, Plus 90i Evolution (355AAV060100) that won't start and gives error code 42 (checked by flashes and on service section on Infinity thermostat). The unit is mounted vertically in the basement, age unknown but thought to be only a couple of years. Was running fine...

Bryant Gas Heater Needs Rebooting time to time [ 6 Answers ]

I have a Bryant gas heater I had installed in 1991. It is a model 394 and the model number is 394GAZ203675. From time to time the heater stops coming on and of course I don't notice it until I start to get cold. As soon as I turn off the furnace and turn it back on it immediately starts up and...

Bryant 394GAD024050 - Fan runs all the time in AC Mode [ 6 Answers ]

Hi, Thanks for taking your time to read this post. A while back I asked the question about disconnecting the Heating part of the unit and if I could get the AC to run correctly without it being hooked up. I thought I had the answer but apparently I'm still doing something Incorrect. I...

Bryant 395CAV Furnace Won't Start [ 3 Answers ]

The furnace typically takes three or four ignition cycles before flame extends down burner to reach the flame sensor. It seems to light only halfway down burner on most attempts. Sometimes reaches shut off and then I have to flick switch to repeat cycle. Help.

View more questions Search