Kenmore dryer igniter switch and flame detector location

tinker3 Posts: 2, Reputation: 1

New Member

Jul 2, 2007, 09:32 AM

Kenmore dryer igniter switch and flame detector location

I have a kenmore dryer how do you get to the igniter switch and flame detector the model is 110.70202990

Check out some similar questions!

Gas dryer trouble with flame [ 1 Answers ]

My Kenmore gas dryer takes 2 or 3 cycles to do what it used to in 1 cycle. Observing the flame, it runs about 45 seconds then cuts off even with a full wet load. It will cycle back on then shut off again after running about 45 seconds. I suspect that either the thermal limiter, wherever that is, is...

Brayant 80t furnace, 'Limit or flame rollout switch is open"? [ 1 Answers ]

HI, I am new here and am having a furnace problem. As a new homeowner I would like to take a look at this myself before just grabbing the phone books. I have a Bryant 80t furnace. Built in 2000 and has been serviced every other year. Unit is clean and in good shape. Woke up to a cold house and...

Igniter location [ 1 Answers ]

Hello again. What location of igniter in honda civic 97 coupe. Engine D16Y7. I can not find it. Thanks.

3 Way Switch Location & Stairs [ 1 Answers ]

There is a three way switch at the bottom of a 15 step staircase. I'm sure this location is okay. However, the other 3 way switch is located in a hallway at the top of the stairs approximately 4' to the left of the door. I looked at 210.70(A)(2)(c) and am wondering if this location is...

View more questions Search

Check out some similar questions!

Add your answer here.