Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Roof truss question?
[ 1 Answers ]
So I had an engineered roof truss made for me by a local company for my garage and they are on a 28 foot span with no load bearing walls. The truss has a room built into them that is 14feet wide and the bottom chord is only made of 2x6 with a gusset plate in the middle of the floor span. So now...
Roof Loading Question
[ 17 Answers ]
I am in the process of fixing up an in-law unit built by the previous owner. Unfortunately, the roof wasn't well constructed. It basically consists of 2x4's running off a ledger attached to the adjacent garage which are then notched and resting on the top plate of the in-law unit (see pictures). ...
Vent out roof question
[ 1 Answers ]
Hello all. I had a question about the vent coming out of the roof. In my kitchen, I have a cathedral ceiling framed with 2 x 12 joists. I was planning on bringing a vent from behind my sink straight up through the roof. I have a 18" overhang, and this will place the vent close to the edge of...
Roof venting question
[ 1 Answers ]
Is it OK to join two 2" dry vents in my attic using a 3" tee (with 2" reducers). A 3" vent pipe would then be connected to the same 3" tee and exit through the roof. I would like to do this solution instead of cutting two separate holes in the roof for the two 2" vents to exit. Is this... View more questions Search
|