Ask Experts Questions for FREE Help !
Ask
    MeganP's Avatar
    MeganP Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2011, 10:23 PM
    Ask an expert about dryer issues?
    Whirlpool LER4600PQO Dryer - started not stopping at the end of a cycle and going into the next, also is getting overly hot.
    By overly hot I mean even on the low heat cycle the element is getting bright red and clothes come out so hot they will burn your hands. Not to mention that even when in the "off" position the element would heat up so I started unplugging it when not in use. Went to go dry a load of clothes today and it will not turn on in any cycle, however, is still heating up. Will replacing the timer switch fix this or could there be a larger issue?
    Fr_Chuck's Avatar
    Fr_Chuck Posts: 81,301, Reputation: 7692
    Expert
    		  
    #2

    Dec 22, 2011, 12:20 PM
    Quote Originally Posted by Ariusp View Post
    it sond's like a defective termostat easely fixed but expensive if u know what and how to do it. my sugestion is to transport it to the closest repershop to save cash
    ( ps. u need to make an apointment after asking how much u save on driving it to them ure self )
    Please you can't even spell the words you are trying to say what is wrong. Obviously you have no idea what you are talking about, How anyone could even think this was a helpful answer is beyond me.

    To the OP there will be a real expert here in a little while that can help you properly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer issues [ 0 Answers ]

Old sears kenmore. Worked fine for last 18 years, but today just stopped. On fourth load this AM drying fine, adequate heat. Changed load , cleaned lint trap, set setting, pushed start and nothing. Checked door, clear, and safety switch seems opperative. Checked breaker, no issue. Checked voltage...

Dryer Issues [ 2 Answers ]

I have a kenmore catalyst dryer about 3 to 5 yeas old. It just started to default to the high dry cycle/check lint screen flashing/constant beep until dry cycle is completed/and will not allow to change to any other settings. I pulled the plug overnight hoping that it will recycle itself but did...

Kenmore dryer issues [ 4 Answers ]

I have a Kenmore dryer that has stopped heating. I got a multimeter and tested thermostats, fuses, and the element. Everything has a reading but the high temp thermostat, so I am assuming this is the issue. My question is I looked at it and the thing has a rivet holding it in. How would I go about...

View more questions Search