 |
|
|
 |
New Member
|
|
Dec 13, 2009, 06:14 PM
|
|
45 kw generator big enough for new home
The wife and I just purchased a new home with a 400 amp service. I have a caterpillar 45kw prime single phase generator, currently hooked up to existing home(200 amp service),wich I would like to hook up to the new house for standby power during storms. Is this generator big enough for my house or should I look for a larger one. I would like it to run the whole house and not just certain circuits. Not that I would turn everything on during a storm, Just like to have it if I need it.I am aware that a 400 amp transfer switch will be needed. I am curerently looking at the asco units, It is what I have now and has worked like a charm. Any help would be apreciated? Thanks.
|
|
 |
Electrical & Lighting Expert
|
|
Dec 13, 2009, 06:30 PM
|
|
Big enough?? I'd say so!
45kW is 150 amps @ 240v continuous. Even a McMansion can run on this. Like you said though, you have to be conscious as to what you run. Like I would not run a whole house tankless water heater for instance.
It also depends on how many people will be living in the house. Sadly, many mini mansions only have 2 or three people living in them.
BTW, can I borrow a few thousand dollars?
|
|
 |
Expert
|
|
Dec 13, 2009, 07:15 PM
|
|
Of course not knowing the size of your home, what type of heat or air conditining, how many walk in size coolers you may have, and that, Now it should huge, I have ran my entire house on one 1/3 that size, but then why do you have 400 amp service,
|
|
 |
Uber Member
|
|
Dec 13, 2009, 10:12 PM
|
|
The OP probably has a wine cellar, a heated inside pool and a hot tub.
|
|
 |
New Member
|
|
Dec 14, 2009, 03:52 AM
|
|
Thanks guys, sounds like it will work fine.
As much as I would like it to be, there is no pool, hot tub, walk in cooler, or wine cellar. It is 4,600 s.f. though, with two 5 ton a.c. units. Gets a little hot here in Texas.
Once again appreciate the help.
|
|
 |
Uber Member
|
|
Dec 14, 2009, 03:55 AM
|
|
Thanks for the feedback!
|
|
 |
Electrical & Lighting Expert
|
|
Dec 14, 2009, 05:13 AM
|
|
 Originally Posted by Fr_Chuck
......, but then why do you have 400 amp service,
It's hard to get around these days with these large homes. Just the number of circuits alone is usually enough reason. Typically the demand load calc is well above 200A.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Home generator
[ 3 Answers ]
I just purchased a 9000W generator that I plan on using to power my house in the event of a power outtage. The unit is rated for 63amps. It has a one 125V twist lock connector rated at 30amps and a 125V/240V twist connector rated at 30amps. I want to hook this to my house through a transfer switch...
Connecting a generator to my home
[ 3 Answers ]
My home is wired with a 50 amp transfer switch for a portable generator. I just purchased an 8000 watt generator and was wondering if I can still use that transfer switch. The generator has a 30 amp( 4 prong ) outlet instead of the 50 amp( 4 prong ) outlet. Can I just replace the generator end of...
Wiring my home for a generator.
[ 19 Answers ]
After a major ice storm going through and being with out power for days. I was told of a simple way to hook up a generator to my home. So I went to my trusty home store after already buying a generator. I bought the some #6 romex 3 wire with ground and a 30 amp two pole breaker and wired it...
View more questions
Search
|