Ask Experts Questions for FREE Help !
Ask
    prince z's Avatar
    prince z Posts: 3, Reputation: 1
    New Member
     
    #1

    Oct 1, 2009, 04:45 PM
    What is the proper way to wire all wires?
    Im installing a Hunter celing fan and light control model 27182. The switch is equipped with four wires including one black, one blue, one red and one green. On the wall there are a total of 6 wires and a bare wire, 3 black and 3 white. The wires shows as follows: two black wires and two white wires on the top of wall box and one black and one white wire on the bottom of the wall box and the bare also from the top as well. Which is the correct way to wire all these to get the control to work properly?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Oct 1, 2009, 06:06 PM

    How many wires are in the ceiling box. Is this switch designed to control the fan or is it designed to control the fan and the light?
    prince z's Avatar
    prince z Posts: 3, Reputation: 1
    New Member
     
    #3

    Oct 1, 2009, 06:33 PM
    Quote Originally Posted by hkstroud View Post
    How many wires are in the ceiling box. Is this switch designed to control the fan or is it designed to control the fan and the light?
    In the ceiling there are 2 wires, one black one white and one for the ground and the control is desinged to control both fan and light.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Proper wire sizing? [ 3 Answers ]

We are re-routing the supply line to our pump house, where there is an extension panel with 30A 220V (pump controller) and 15A & 20A 110V breakers. It's about a 60' run from the 200A main service in the house, being placed in conduit 2' underground. The wire in place is newer 10 gauge solid copper....

Proper wire gage [ 1 Answers ]

Currently my sub panel in the garage is supplied by 10 gage 2 wire with ground from a 30 amp dbl pull breaker in the house. The run is 30' to the 100 amp box in the garage. The garage is a part time workshop with several power tools on at the same time along with 10 4' fluorescent light fixtures...

Proper wire sizing? [ 1 Answers ]

What is the wire size needed to run a 240 volt single phase 125 amp around 100 feet?

Proper wire and conduit size? [ 2 Answers ]

Hi, I have just had a new pole building built. I had a 200 amp service installed. I will be installing 16 fluorescent light units. I will install them on at least 2, possibly 3 circuits. My question is what is the formula for figuring out the proper wire size, and how many of these conductors can I...

Proper gauge wire to run to hot tub? [ 5 Answers ]

I am trying to run wiring from my main service panel to a hot tub on our back porch. My father was an electrician, so I have a fairly good base of knowledge, but I wish he was alive to help me out. To save on the electrician install, I was going to install the 240 breaker in the box and then run...


View more questions Search