Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Installing a floating floor over existing parquet floor
[ 4 Answers ]
I live in a condo and currently have 8" square oak parquet floors. The parquet is half an inch thick and glued down to the concrete subfloor (it is glued with a think black substance that I was told is tar). The flooring has been in the building for nearly 50 years and seems to be well intact...
Installing a tub on cement floor
[ 3 Answers ]
We are trying to install a tub in the basement. Drain is already in place trying to make room for pluming of tub?
Installing Bathroom on 2nd Floor
[ 3 Answers ]
We want to install a bathroom on our 2nd floor. Our house is built on a slab and we have a septic system. The bathroom we want to install would be directly over a 1/2 bath on the 1st floor. Is it possible for these two toilets to share the plumbing that goes out to the septic tank? Can you just...
Installing 2nd floor bathroom
[ 2 Answers ]
I am working on installing a 2nd floor bathroom in my house. The bathroom will be next to the water heater (though I may replace the 50gal with a instant demand heater) so water in to the bathroom is no problem. My problem is a drain for the sink, shower and toilet. The bathroom will be about 6'...
Installing a floor transition
[ 5 Answers ]
I bought Carpet Trim which came with nails at Lowe's, I'm transitioning from tiles to carpet. According to instructions I'm supposed to use the included nails to fasten the trim to the concrete floor. All nails bend as I try to drive them into the concrerte. Any suggestions? View more questions Search
|