Ask Experts Questions for FREE Help !
Ask
    mr500's Avatar
    mr500 Posts: 181, Reputation: 8
    Junior Member
     
    #1

    Mar 19, 2008, 02:22 PM
    Running Conduit
    Im about to run my feeder into my new workshop and was wondering when I drill down through the bottom plate and bring in my feeder, what's the codes say about this part of the wire having to be in conduit? I mean the part from the floor up to the bottom of my panel?

    Also, is it within code to use plain 12 awg (green) for pigtails on the grounds? I can't find plain copper in 12awg. Probably a stupid question there, but I just wanted to know. LOL
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Mar 19, 2008, 04:59 PM
    Ground can be green or bare. I would just run Conduit to panel, If PVC You can heat to make an offset, If Metal, you may need a bender.
    It can also be solid or stranded.
    mr500's Avatar
    mr500 Posts: 181, Reputation: 8
    Junior Member
     
    #3

    Mar 19, 2008, 06:20 PM
    Ok PVC it is then

    Thanks
    Mike

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to size Conduit 6-3 [ 4 Answers ]

I have 2 6-3 for a 60ft run and 1 6-3 for another run. Question, what size conduit do I use. This circuit is for a tankless water heater. All will in my garage which is drywalled.

Running pex under slab in pvc conduit [ 1 Answers ]

I have a 10' run of 1/2" pex I want to run under a slab that will be poured. Everything I have read says that you must use a non-metallic elbow (such as PVC) to bring the PEx up through the slab. I am running this line for an island sink supply. I would feel more comfortable if I not only ran it...

Running -- supporting (?) EMT conduit [ 1 Answers ]

Well, again I have a question that the NEC code book seems pretty vague on. I’m looking at Article 348 and 370 – on running conduit. What I’m doing is wiring my “pole barn” (see prev. posts & great ansrs/help on the “branch ckt” and the grounding”). The barn has what they call “girts” …...

Bath tub shower spout & head running water running at same time [ 1 Answers ]

I started with a slight dripping problem(sayko system).i decided to replace all 3 stem assemblies together as they all were about 18 years old.after reassembling the new stems(danko brand),turned on the water supply & checked faucets.hot & cold worked fine but when the shower was turned on,water...

Do I need conduit? [ 4 Answers ]

I have a panel in my garage for my garage based workshop. I want to run a 220 volt circuit (have have the capacity in the panel to do so). My question is whether I need to run the wire inside conduit or can I run romex without conduit. The wire will be behind drywall the entire way so it will...


View more questions Search