Ask Experts Questions for FREE Help !
Ask
    91crx211ls's Avatar
    91crx211ls Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Mar 16, 2008, 06:55 PM
    91 CRX Starting
    When you turn on the key no lights come on. You try to start and car starts, but doesn't stay running. If yyou hold the key in start position the car stays running. Any help would be appreciated.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Mar 16, 2008, 07:48 PM
    The ignition switch and harness likely needs replacing:

    1. Disconnect negative battery cable.
    2. Remove dashboard lower cover and knee bolster.
    3. Disconnect 5-P connector from under-dash fuse box and 7-P connector from main wire harness.
    4. Remove steering column covers.
    5. Insert key and turn it to "0".
    6. Remove two screws from switch and replace.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

84 Honda CRX [ 11 Answers ]

After 238,000 miles, my Honda suddenly developed a sputtering problem one day while I was just crusing down the road. I have to pump the gas pedal, and/or downshift to keep it running. It doesn't take much under load, I have to barely push or pump on the gas pedal, to build up speed. I know this...

Crx 1991 [ 1 Answers ]

Hi all got a 91 crx with v-tec 1.6 from acura integra B16A1 No Spark at plugs any IDEAS?? David:confused:

91 crx codes [ 3 Answers ]

Ok, I went and did some snooping around today at my vehicle and the codes I got from the ECU are as follows. 3- MAP sensor 6- coolant temp sensor 10- TA sensor 13 PA sensor

89 CRX problems [ 9 Answers ]

Hello, new to this site, and thanks in advance. Great site. Well here goes. My car wouldn't start, no spark, so I took off distributor cap and saw that there piece (rod?) that goes into the coil was fried. I replace the cap with a new one, still didn't fire up. I then replace the ICM, it...

View more questions Search