 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Where would I get a filter for a Beckett model AFG oil burner and what model # would it be?
Look for a round filter somewhere on the oil line. Take the number offf of it and by your filter on the net.Beckett is a burner name not a filter name. |
||||
|
||||
|
I looking at your post "oil burner maintenance" there is MUCH more to maintain a safe and reliable oil burner... change primary fuel filter, and pump filter, check pump pressure, change oil nozzle, set and clean electrodes, clean CAD cell, field check transformer spark, vac / clean combustion chamber, check & clean venting, and MOST importantly verify the operation of the SAFETY devices ( primary control & limits)... Just to give you a bit more information... this kind of maintenance needs to be done by a HVAC professional, and is beyond the scope of this web site... your safety is the MOST important issue to all of us professionals that answer posts at this site!!
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I Reset My Oil Burner All Day Every Day Just As The Water Begins To Get Warm It Cuts Out. If I Try To Reset It Once It Cuts Out It Will Try But Won't Ignite. If I Leave It For A While It Will Eventually Come On. Santa Is On His Way And My House Is Getting Colder By The Day Can Anyone Help Please
That 1 you see as a response to my boiler question was to redirect my boiler question to heating and cooling. Please refer to boiler burner dripping below. Still need an answer as am not willing to have the tricky oil companies service my problem after causing it. They want to see more dollars...
My oil burner repairman cannot figure out why the oil is blowing back into the part that is attached to the pump. Everything has been replaced, nozzle, pump, eye, etc. It is a Beckett burner and the nozzle that is in there is .75/80 hollow. Why would the oil blow back, 0other than the nozzle is...
I have an oil burner and want to add and air conditioner unit,do I need a second 24v thermostat for the cooling circuit
The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is...
View more questions Search
|
