Ask Experts Questions for FREE Help !
Ask
    ksday's Avatar
    ksday Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 27, 2008, 05:44 AM
    Location of the flamer sensor in a Bryant Model 383K Furnace
    Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer.

    I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in advance for your help!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Feb 27, 2008, 07:22 AM
    Located near the pilot lite in the burner area. The pilot actually touches the sensor.
    ASIHVACR's Avatar
    ASIHVACR Posts: 2, Reputation: 2
    New Member
    		  
    #3

    Feb 27, 2008, 07:31 AM
    Quote Originally Posted by ksday
    Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer.

    I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in advance for your help!
    The flame sensor should be fairly easy to find. It would be a metal probe about an inch or two long, thinner than a pencil and it would be right in the main flame of the burners. If you have a flame style pilot it may be part of this assembly.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #4

    Feb 28, 2008, 08:17 PM
    The flame sensor will be opposite side of your hot surface ignitor in front of the burners.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Furnace model 383KAV won't kick on [ 10 Answers ]

I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...

99 Nissan Altima Knock Sensor Location ? [ 1 Answers ]

Can anyone tell me where the knock sensor is located on a 1999 Nissan Altima, 4 cyl automatic trans. Thanks for your help

MAP sensor location [ 1 Answers ]

Where is the MAP sensor located on a 1994 Honda Civic? Thank you

No heat. Bryant 383k upflow gas furnace [ 1 Answers ]

12 yr old Bryant 383k upflow gas furnace. When first starting blowers run through three cycles then furnace locks out. Tried reseting Darft Safegaurd tube switch and Manual Reset Limit switch. Replaced filter. Have other gas appliances that work fine.

1998 Altima knock sensor location [ 2 Answers ]

Can somebody tell me where the knock sensor is located on a 1998 Nissan Altima 4 cyl? Thanks, Mark M:)

View more questions Search