 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore Ultra wash Issues
I have a Kenmore Ultrawash QuietGuard 3. It is only about 2 years old if that. It worked fine last night, but I went to use it today and it went through the cycles, but no water... and when it was done the clean light just kept blinking, and it would not let me do anything else. I read on another site to reset.. by pushing the hi-temp- heated dry sequence, it seemed to reset, and do a few things, but when I tried to start the cycle again, I got the same results... no water... I have checked that the hoses are good, the float isn't stuck, etc... please help!
|
||||
|
||||
|
Try removing the hoses from the back of the unit to verify that you actually have water pressure reaching the unit. If there is water pressure locate the two water fill solenoids and watch to see if the timer is sending them the signal to open, put a 120 v. tester lead on the wires and wait for the signal.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Just got a used kenmore ultra wash portable dishwasher model#110764511 and need to figure out the buttons on it
My dishwasher has been working fine until one day it just won't run a new cycle. The clean light is flashing and when I press the start button, the clean light proceeds to flash several times. Please help!:confused:
I have a Kenmore ultra washer and the water spinner that hooks on the upper chamber, where you put the dishes fell off. I tried to put it back on but was unable to. Is there a tool I need or do I need to get a repair man? Please let me know. Thank You
I have a kenmore ultra wash that I inherited with a house about 6 years ago. All was fine until recently when it became apparent that the dishes were no longer coming out of the dishwasher clean. Glasses come out with a film on them, silverware still looks dirty, plates dirty... Has the thing...
View more questions Search
|
