I have a Kenmore Ultrawash QuietGuard 3. It is only about 2 years old if that. It worked fine last night, but I went to use it today and it went through the cycles, but no water... and when it was done the clean light just kept blinking, and it would not let me do anything else. I read on another site to reset.. by pushing the hi-temp- heated dry sequence, it seemed to reset, and do a few things, but when I tried to start the cycle again, I got the same results... no water... I have checked that the hoses are good, the float isn't stuck, etc... please help!

Try removing the hoses from the back of the unit to verify that you actually have water pressure reaching the unit. If there is water pressure locate the two water fill solenoids and watch to see if the timer is sending them the signal to open, put a 120 v. tester lead on the wires and wait for the signal.