 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Honeywell RTH230B heat only wiring
I've installed the 230B thermostat in my basement to control one zone of baseboard heat. The furnace is oil fired hot water and all the zones are run by zone valves. I must be missing something because the thermostat is not controlling properly.
Because I'm only using this for heat how do I hook this up properly? Also, there is a jumper in the thermostat but I'm not sure if I should leave it there or remove it. Here is a link to the thermostst instructions. http://www.silverbowproperties.com/i...ll-RTH230B.pdf Thank you for your help. |
||||
|
||||
|
Thinking you only need the 2 wire heating only instructions,, red wire to rh white wire to w, the jumper which is probably jumping from rh to rc, which isn`t needed unless you are trying to send a signal to a/c,, if you are using a 3 wire system the 3rd wire probably green should go to the g post,, for fan, hope this is of some help
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I'm trying to install a rth230B, but my wiring connection choices do not match up with my current T-stat wires. Note: My current digital T-stat is a power sharing model (ie. no batteries) and the rth230b uses batteries, so I have that difference right out of the box. I have a single stage gas...
I'm trying to install a rth230B, but my wiring connection choices do not match up with my current T-stat wires. Note: My current digital T-stat is a power sharing model (ie. no batteries) and the rth230b uses batteries, so I have that difference right out of the box. I have a single stage gas...
The wiring out of my wall for my thermostat is Blue, Red, Green, Yellow, and white My old nonprogrammable thermostat's wiring was connected by C (blue),R (red),G(green),Y(Yellow),W(white) My new Honeywell RTH230B has connections for Rh, Rc, G, Y, W
I'm installing the rth230b on a 3 wire gas fired boiler. The wires are blue, red, white. On the old mercury stat the blue and red wre on the same post. Anybody know how I should wire this one? Thanks! Mike
I have an existing Honeywell non-programmable thermostat with 2 wires, a white and black. I 'd like to replace with the RTH230B programmable. After reading the Reader's Digest Do-it-Yourself book, it says I would need to add wires if I wanted to replace a non-programmable thermostat with a...
View more questions Search
|
