Ask Experts Questions for FREE Help !
Ask
    hkwv44's Avatar
    hkwv44 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 30, 2008, 08:01 AM
    SEU & Romex
    Can SEU and NMB cable be uses interchangely for a 60 amp, 240 volt circuit.
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #2

    Jan 30, 2008, 10:48 AM
    Please restate the question.

    Give more detail.

    What size wire for both cables?

    Aluminum or copper?

    If this helps, NM-B cable must use the ampacity rating listed in the 60 Deg C column of the Table 310.16, while SE cable can use the 75 Deg C column.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring of a 200AMP main panel - SEU wires entry point [ 3 Answers ]

Hello, I am putting a new 200AMP main panel in a service upgrade. Its location is a little higher than the meter socket. The panel and the meter are back to back on a wall (meter outside, panel inside). Main disconnect is at the top of the panel, as are the connections for the SEU cable. Can I...

Romex wire [ 2 Answers ]

Is Romex Wire Legal In New York City?

SEU/Load panel [ 13 Answers ]

I’ve seen questions here similar to mine, but I just need to be sure about a few things before I proceed. I have to move the main load panel appx. Four feet from its present location and I will be replacing the junk Federal Pacific (FP) unit with a new main breaker panel. The FP is inside, and...

Romex or bx [ 1 Answers ]

Hello, My niece is having some electrical work done in her hi rise condo, in manhattan NYC I notice romex cable being used, I always thought bx cable was code for NYC Any info is appr. Thank you

Subpanel/SEU/conduit [ 1 Answers ]

I read a previous post here referring to SEU cable, and due to its construction, it could be run indoors to the load panel without using conduit. I need to install a sub panel for my air compressor and welder. The sub panel will be in the attached garage, and the total distance between the main...

View more questions Search