Ask Experts Questions for FREE Help !
Ask
    chiguy13's Avatar
    chiguy13 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jan 24, 2008, 05:42 PM
    My GE Dryer isn't drying.
    I have an older GE Dryer and it doesn't get very hot. It takes over an hour to dry a small load. I've cleaned the lint trap and that's about it.
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
     
    #2

    Jan 24, 2008, 08:04 PM
    Clean the blower housing on the inside. Clean the vent exhaust from back of unit to where it exits the house. Problem Solved
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #3

    Jan 24, 2008, 08:15 PM
    Assuming that this is an electric clothes dryer.

    Probably defective heating element or high or low temperature sensor. Repair can be done by a reasonably competent handyman type person.
    Diagnosing burned out heater is easy, you can usually see that the heating coil is burned into. If not check with an ohm meter. Determining if one or both of the temperature sensors is defective is a little more difficult.

    Unplug dryer. Lay a blanket or some other soft material on the floor in front of the dryer. Turn dryer over on its front. Remove back panel. Look for heating element, will have to fairly large wires going to it. Disconnect wires. Remove the 2 or 3 small screws holding in place. Remove and examine it. The element itself will look like a spring and will probably be enclosed in a metal frame. If element is broken that's you problem. Replace. The elements are fairly generic and can be found at appliance parts stores. If heating element appears to OK and you suspect temperature sensors, I suggest that you just replace both and not worry about determining which one is defective. Temperature sensors will be round, about 1" in diameter and about 3/4" thick.

    Footnote.
    Should you decide to replace rather than repair, most older dryers used a 3 wire hook up. Some new dryers require a 4-wire hook up, some can be either. If you replace with a 4-wire you may have to have electrical work done.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dryer not Drying all the way [ 4 Answers ]

I have a GE dryer that doesn't seem to dry all the way. I've cracked it open and cleaned out all the dust buildup from the vents (there was quite a bit) and the blower moter and blades. Should be clean as a whistle now. The heating element was clean and shows no cracks and looks to heat up OK...

Dryer Not Drying [ 1 Answers ]

I Have A Whirlpool Dryer And It Is Not Drying The Clothes At A Very Fast Rate. I Have To Run A Regular Size Load Through The Cycle Two Times Before They Are Dry. My Vent Is Kind Of Weird, Where My Laundry Room Is The Vent Has To Run Up Through The Roof And I Don't Know If This Has Something To Do...

Dryer not drying [ 1 Answers ]

My frigidaire dryer is heating but not drying in the appropriate time. It takes forever for the clothes to dry. Could this be the heating element?

Dryer not drying, heating [ 3 Answers ]

Help! I would like to fix this myself! My electric dryer is heating, but not drying my clothes. My lint trap is always clean every time I check it- which is weird because usually it needs to be cleaned between loads! When I open my dryer door (my dryer keeps going even when I open the door-...


View more questions Search