Ask Experts Questions for FREE Help !
Ask
    FF4Him27's Avatar
    FF4Him27 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 22, 2007, 09:37 AM
    Blower timing switch?
    My heater cycles on and off all night. Stays on for about 1 minute then turns off. I tried adjusting the blower timing switch, but it does it regardless whether it's set in the long delay or short delay. My question is: Where SHOULD the blower switch be set at?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Dec 22, 2007, 05:58 PM
    Is this a gas fired unit or a heatpump?
    FF4Him27's Avatar
    FF4Him27 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 23, 2007, 10:31 AM
    Gas fired unit
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Adjusted Limit Switch Now Blower won't Turn On [ 1 Answers ]

I turned on the furnace for the first time last week and the blower woudn't turn off. I did some research on this site and upon investigation the limit tab setting was set at 150 and the "on" was all the way up to the limit tab at 150 as well. The "off" was set at 50 and I think that's why the...

HEAT-OFF-COOL system switch - AUTO-ON fan switch. [ 2 Answers ]

Dear Gurus, I am a new house owner & not used to thermostats. We have Honeywell 8112D thermostat. We recently turned ON our Fan switch (in the thermostat). Now the fan is not turning off. It is continuously running even when the system is in OFF & Fan is in AUTO mode. We tried reducing the...

Speed Selector Switch for Reclaimed Furnace Blower [ 6 Answers ]

I have an Emerson furnace blower (5 speed, 10 amp, 115V, 3/4 hp). I am looking for a switch to at least operate 3 speeds and how to connect it. The wire colors are white, black, yellow, blue, red, and brown. In addition I would love to put a timer in-line. The model number is K55HCNNZ-7057 for...

Furnace blower switch [ 1 Answers ]

I have a gravity furnace. On one leg of the system I' ve Placed a small 110volt blower fan with a manual switch. Is there any type of switch that can be wired into the 24 volt furnace thermostat so the blower only runs when the furnace is on.. I've added this to give a little heat to the...

View more questions Search