Ask Experts Questions for FREE Help !
Ask
    rilocool's Avatar
    rilocool Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 10, 2007, 09:30 PM
    Dog eat a/c wire, world!
    My Dog has chewed through my carrier a/c wires and I really need to reconnect them back, how do I do so. There are green, red, and white wires?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 11, 2007, 04:44 AM
    Connect the same colors back together.
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Dec 11, 2007, 05:20 AM
    If it is the wire to an outside unit, and there isn't enough left to do as above, go to the furnace and run a new pair of wires from the Y and com terminals of the furnace to the coil terminals of the contactor. The outside compressor unit should only need the 2 wires. If the third wire is used, it may go to Y2 where the thermostat controls a 2 stage unit.

    My one puppy not only chewed the control wires, but the foam on the vapor tube too, and was working on the flex for the 240.

Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hard wire 3 wire to 4 wire 220 service [ 1 Answers ]

How do I hard wire my 3 wire (red,blk & bare copper wires) 220vac cooktop to the 4 wire (black/white stripe,black/red stripe, blk/blk & bare alum wires) in the house supply j-box ?

Hard wire 3 wire to 4 wire 220 service [ 2 Answers ]

How do I hard wire my 3 wire (red,blk & bare copper wires) 220vac cooktop to the 4 wire (black/white stripe,black/red stripe, blk/blk & bare alum wires) in the house supply j-box ?

Neutral wire is hot(has voltage potential like the black wire) [ 5 Answers ]

Hi, The problem started at midnight last week. One of my line in the basement is starting to have issue whenever I connect a water pump or appliances to the outlets. Before I plug the appliance in, the neutral is neutral(zero voltage), but when I plug the appliance in, the neutral is now...

3-wire home, 3-wire fan, 2-wire remote [ 9 Answers ]

Greetings, My home is 3-wire. I bought a Hunter ceiling fan (model 23811). The fan came with a remote assy. That I do NOT want to use... The fan has standard 3-wire connections (black, white, blk&white strip, ground). The remote receiver home-side wiring looks to be for 2-wire (blk and white)....

2 Wire White-Rogers with no wallplate wire question [ 2 Answers ]

Hi there. I want to replace my current White-Rogers 1E56W309 thermostat with a new Honeywell RTH7500D. The problem is that the tools that installed my high efficiency furnace didn't install the wall plate with my thermostat (it was a new house and the builder contracted these guys). Instead,...

View more questions Search