Ask Experts Questions for FREE Help !
Ask
    Sparksfarm1's Avatar
    Sparksfarm1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 3, 2007, 03:27 PM
    Well Pressure Tank
    Ok... here's the question:

    I shut the main water valve off so I could work on replacing the washer hoses. Did the work, turned the water back on and now I have nothing!

    We tried knocking on the tank... nothing. We emptied some of the water from the tank... nothing. All electrical is OK and was not touched...

    Anyone?

    Thanks,

    Dean Sparks
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Dec 3, 2007, 05:18 PM
    Quote Originally Posted by Sparksfarm1
    Ok.....here's the question:

    I shut the main water valve off so I could work on replacing the washer hoses. Did the work, turned the water back on and now I have nothing!

    We tried knocking on the tank...nothing. We emptied some of the water from the tank....nothing. All electrical is ok and was not touched......

    Anyone?

    Thanks,

    Dean Sparks
    Well, it would seem the pump is not cutting in. Is the switch cutting the pump on?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #3

    Dec 4, 2007, 06:10 AM
    All electrical is OK and was not touched...
    Are you saying the pump control contacts are closed and the pumps running dry or does the pump not run at all?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pressure/bladder tank losing pressure? [ 11 Answers ]

Well, I have asked some questions about my plumbing before. So I am calling on you guys once again. I have a 52 gallon pressure tank/bladder tank made by wellsaver. I turn the water on and have good pressure for a few minutes then it basically goes dead with no pressure. I recently posted questions...

Bigger pressure tank or increase pressure? [ 5 Answers ]

I bought a new home and the builder had installed a 20 gal pressure tank. I have a jet pump system where the motor sits directly on the tank itself. I really notice the pump running a bit,but also notice the loss of pressure quickly, especially in the shower. Now I was thinking of buying a much...

Well Tank Pressure [ 1 Answers ]

My well tank is building pressure to the point where the pressure release valve continually leaks water. I tried emptying the tank and restarting. As soon as I did this the tank built pressure to over 90 and the pressure release valve again began leaking a lot of water. Any ideas? Thanks,...

Tank Pressure vs Pump Cut Out Pressure for Well [ 1 Answers ]

I am trying to increase my water system pressure to the minimum required 40 PSI to feed my reverse osmosis drinking water filter. However, the 33 gallon pressure tank for my well pump system says it is pre-charged at 30 PSI and that the cut in pressure for my pump should be set equal to that 30...

New pressure tank? [ 1 Answers ]

I recently had my well pump replaced. Ever since, the pump kicks in after a gallon or two of water use. I called the well pump installer immediately when we noticed the problem (which did not exist until he came out to replace the pump), but he won't show up to check it out. Kidnapping him and...

View more questions Search