Ask Experts Questions for FREE Help !
Ask
    Tofu4679's Avatar
    Tofu4679 Posts: 10, Reputation: 2
    New Member
     
    #1

    Dec 1, 2007, 09:37 AM
    Lights dimming in entire house
    We're having an intermittent issue with lights dimming in the entire house (or at least on different circuits at the same time). I do NOT notice any brightening of the lights, just dimming. The lights will flash from normal to slightly dim and back and forth usually for about 2 or 3 seconds then calm down for a while. I've been trying to pin point a particular appliance but when it happens nothing is running. Also, when our refrigerator compressor or clothes dryer starts up the lights dim briefly. I understand that this can be normal, however we have never noticed those particular appliances dimming the lights before. We'll have the dimming issue even when most everything is off in our house so I don't thing we are overloading. The grounds/neutrals are tight in the breaker box. I haven't tightened the main neutral from the utility as I don't have the right size hex bit yet.

    Christmas lights/trees have recently gone up around the neighborhood and in our house. Can the extra load in the neighborhood cause problems from the utility company? Could a problem with our Christmas tree lights or Christmas lights on our house dim the entire house? I would think it would only effect the one circuit, or at most only one phase. Where should I look in the house and what are the troubleshooting steps? Should I call the utility company first?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Dec 1, 2007, 10:29 AM
    Yes, contact the utility. If the dimming just started with all the Xmas lights in the neighborhood,then the transformer may be overloaded, or defective, or there is a loose connection in the utility system.

    The loose connection may be in just your line from the utility.
    Tofu4679's Avatar
    Tofu4679 Posts: 10, Reputation: 2
    New Member
     
    #3

    Dec 1, 2007, 04:04 PM
    The utility came out and discovered the neutral was loose in the meter box as a result of the ground settling beneath the box. This sounds like it was most likely our issue.

    Thanks

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lights dimming [ 1 Answers ]

What should I look for when troubleshooting lights that dim. When a contractor plugs in paint sprayer or air compressor it causes the lights to dim in the hallway. Too many circuits on that breaker? Or ---- Guy

Lights on one circuit keep dimming [ 3 Answers ]

Hello, I live in a home built in the 40's. It has the old cloth covered wiring, new panel and breakers (6 years old). I have one circuit (which is very much overloaded) that never had a problem before (as long as the blow dryer wasn't on with anything else). I recently replaced a switch in...

Newer dimmer not dimming after replacing wall lights [ 1 Answers ]

I replaced two wall lights today, 6 incandescent bulbs, total 240 watts. They turned on, but would not dim. The dimmer is a newer, less than 2 years, a Leviton or Lutron, toggle style dimmer. Should I replace the dimmer?

Dimming lights a safety issue? [ 2 Answers ]

Folks, My lights dim when we run the vacuum, carpet cleaner or any other bigger appliance. I have seen lights dim before and then fade back on to normal after a few seconds. Ours do not do that, they simply dim and stay that way until you turn off the device... Question... Is this a problem or...

Dimming by pull chain the ceiling fan lights [ 1 Answers ]

I have no wall switch for my ceiling fan lights or the fan itself. I wish to find a 3 position pull chain light switch so I can have OFF, FULL AND DIM for the lights. For DIM I would put a IN 4003 diode in series with that position wire. - That would give me 1/2 dimming. My problem is: I can't find...


View more questions Search