Ask Experts Questions for FREE Help !
Ask
    rward's Avatar
    rward Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 29, 2007, 02:46 PM
    Confused about wiring schmatic on Honeywell Thermostat
    I have a gas fired single stage heat furnace and I am trying to install a HoneywellCT3200 progrmable thermostat. The wiring coming off the old thermostat has three wires Red, Black, Green. There is no corresponding letter for the black wire or perhaps I should not be using this particular model, It says its compatible??
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 30, 2007, 04:08 AM
    Follow wires to the furnace to see where they go. Then wire as per your instructions contained with your new stat.

    Just in case you tossed your instructions away see below.

    http://customer.honeywell.com/techli...0s/69-1631.pdf
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Nov 30, 2007, 05:30 AM
    The furnace may be marked the same as the thermostat. If not, the wire coming directly from the transformer goes to R or RH. The one from the gas valve goes to white. It is possible the third wire comes from the transformer too. In that case, you will need to sort out which should be hot and which is common. The sticky at https://www.askmehelpdesk.com/heatin...ons-58313.html
    Will help.

    Although in many cases the green is to the fan relay, it may not have been in your old system.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring honeywell thermostat [ 2 Answers ]

Dear sir, I purchased a honeywell digital thermostat, non programmable, and replacing the honeywell mechanical. The prooblem is i used terminals g y o w2on the old the new has e aux ygolrbc,i can hook up the gyo but,where does the brown wire go.the new honeywell is for heat pump also th321od ...

Wiring for a RTH110B Honeywell Thermostat [ 4 Answers ]

My old thermostat had six wires, blue, red, green, white, yellow, and black. But my new Honeywell RTH110B none programmable thermostat only gives instructions for wiring up to 5 wires (Rh, Rc, W, Y, G). How do I wire my new thermostat using the six previously used from my old thermostat? ...

HoneyWell Thermostat Wiring RTH230 [ 2 Answers ]

Hi, I am trying to install a HoneyWell RTH230 programmable thermostat to replace our old Honeywell round thermostat. I have a Miller gas furnace and electrical central air. The wiring to the old thermostat was as follows: Red Orange White Yellow Green

Honeywell RTH230B thermostat wiring [ 3 Answers ]

I'm trying to install a rth230B, but my wiring connection choices do not match up with my current T-stat wires. Note: My current digital T-stat is a power sharing model (ie. no batteries) and the rth230b uses batteries, so I have that difference right out of the box. I have a single stage gas...

View more questions Search