Why it won't lite

jsneeze Posts: 7, Reputation: 1

New Member

Nov 20, 2007, 04:46 PM

Why it won't lite

Why my beckett furance oil won't lite

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Nov 20, 2007, 06:43 PM

Check to see if you have oil.

Add your answer here.

Check out some similar questions!

Gas fireplace won't lite,pilot light is on [ 7 Answers ]

I turned my gas fireplace on and the pilot lit fine and stays on but I can not get the main fire to go on. I have cleaned the thermocouple and other device on other side of pilot and also tried jumping the thermostat at wall and at fire place but no luck.

Feather Lite Plus Weedeater [ 3 Answers ]

I have a 7 year old Feather Lite Plus weedeater. Just resently it's gotten to where it will not stay started. It starts just fine, it just won't stay started. I've checked the filter, it's clean. I've checked the primer pump and it flows fine. Any advice?

Bryant furnace won't lite [ 3 Answers ]

Hello, I have a Bryant furnace. It Keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out...

Nintendo ds lite [ 2 Answers ]

I have bought a nintendo ds lite in canada for my daughter as we are moving there early next year, my question is how do I use it in england as it has a two prong plug and the voltage is different any help appreciated:confused:

Faulty lite [ 3 Answers ]

:confused: I recently installed a flouresent lite fixture and after being on for ten or fifteen minutes, it shuts off. Is the ballast bad or something else going on? Thank-jb.