Ask Experts Questions for FREE Help !
Ask
    curiousminds's Avatar
    curiousminds Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 16, 2007, 10:17 PM
    Safe to lubricate the Inducer?
    We were having problems with our Lennox Elite G51. The fan on the inducer seemed to be seized; however, with a little nudging we have it going again but it's making more noise than usual. It looks a bit rusty inside from what we can see through the slots. Is it safe to squirt a bit of WD-40 or another lubricant (recommendations?) in there or will it damage the motor?

    On a side note, when we ripped apart the furnace there was water in the inducer, is this normal and if not, what can we fix or check to make it quit happening.

    Thanks in advance for any answers!
    hixton's Avatar
    hixton Posts: 146, Reputation: 5
    Junior Member
     
    #2

    Nov 17, 2007, 09:53 AM
    WD 40 could start on fire don't use that sounds like you need a new inducer if gets to loud check the drains I think they might have a new drain kit to drain the water from the housing of the inducer check with your dealer

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lubricate Sliding Glass Door [ 6 Answers ]

Our sliding glass door to the backyard has become more difficult to open and I'm wondering what can be done, if some type of lubricant is supposed to be used or does it need some repair to the metal track or the door itself. Any suggestions/resources are appreciated.

Goodman Inducer Motor [ 18 Answers ]

I have a Goodman Gas Furnace installed in 1997 and have been experiencing the following problems: The usual run for the furnace has been inducer motor on, ignition (with flames), and then the blower motor comes on. I have been having the inducer motor come on, run for about three minutes,...

Hvac inducer [ 2 Answers ]

What does an inducer do on a hvac system. Is it a problem if the gasket is bad on the inducer?

Replacement Inducer [ 10 Answers ]

What is the replacement inducer for a horizontal Carrier 349MAV036075 furnace? Currently, the inducer blower is a Fasco 7162-3136. The Fasco website suggests the A142 but with the inducer mounted blower upward on the furnace the condensation drain nipple on the inducer is at the 9 o'clock...

Inline inducer [ 3 Answers ]

The room over my garage is the furthest room my furnace. It is colder in the winter and hotter I the summer than the res of the house. I am thinking of buying an inducer to boost air flow. Should I install the one with the heater as well? What happens in the summer with air conditioning? Where is...


View more questions Search