Ask Experts Questions for FREE Help !
Ask
    doitmyself1963's Avatar
    doitmyself1963 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 15, 2007, 01:25 PM
    Kenmore Dryer Willnot heat MD# 110.66862501
    I have a Kenmore Dryer. 1 1/2 years old it will run but will not heat. Help
    sleddinboi's Avatar
    sleddinboi Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Nov 15, 2007, 02:47 PM
    The element is prob burnt
    cgood's Avatar
    cgood Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Mar 28, 2010, 06:16 PM
    If you can use a volt-ammeter, unplug it and take the back off. Check for near 0 ohms on all the little black things with two wires (thermostats) and low ohms on the two tabs coming out of the bottom of the silver heater column at the right (heater coil) One of them is likely to be open.
    cgood's Avatar
    cgood Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Mar 28, 2010, 06:16 PM
    If you can use a volt-ammeter, unplug it and take the back off. Check for near 0 ohms on all the little black things with two wires (thermostats) and low ohms on the two tabs coming out of the bottom of the silver heater column at the right (heater coil) One of them is likely to be open.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Elite Dryer Model 110.63932102 will not heat [ 6 Answers ]

My dryer stopped heating although it runs. I confirmed I was getting 240volts at the source. I checked the continuity of the element, the thermal fuse and the thermostat and found that they were continuous. I have read that the thermistor might have something to do with it...

Kenmore Dryer Model # 110.96591220 Won't Heat [ 5 Answers ]

Dryer won't heat and I have continuity on all the reachable parts. Not getting juice to the coil during operation. I should have 0.00 OHMS for normal operation, tested when cool on all the parts, right? Thanks for your help.:eek:

Kenmore 110-74672400 Gas Dryer WIll Not Heat After I cleaned all the Vents out! [ 1 Answers ]

All I did today was tilt the dryer forward while I disconnected the vent lines and cleaned all of them from the back of the dryer all the way to the outside of the house. Could I have screwed up the Pilot by tilting it and keeping it tilted for such a long time? I thought I would have made the wife...

Kenmore Elite Dryer Model 110.74972301 no heat [ 1 Answers ]

I have a dryer that runs but has no heat. The ignitor do not spark the gas to get the heat on. The model is 110.74972301. I had this on an older model and found a fuse on the back of the dryer that was an overload fuse. Replaced it and it worked. I can not find that on this dryer. Can you...

View more questions Search