Ask Experts Questions for FREE Help !
Ask
    Palacin12's Avatar
    Palacin12 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 20, 2007, 09:37 AM
    Thermostat Installation
    Hi

    How do I connect the thermostat ?

    1) current wring consist of 2 feed and 2 load wires in the wall. The thermostat I want to install has 2 non polarized wires. How do I connect this? Do I connect the feeds to each other and then to the same wire on the back of the thermostat? Then Do the same for the loads? Or do I connect one feed and one load to each other and then to a single wite on the thermostat. 2) What do I do with the current cooper ground wire. There's no place for it on the new thermostat?

    Thanks 4 your help
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #2

    Oct 20, 2007, 01:29 PM
    Do you have a line voltage thermostat?
    Palacin12's Avatar
    Palacin12 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 20, 2007, 07:55 PM
    120 volt
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat installation [ 1 Answers ]

I am trying to install a programmable thermostat. I have 6 wires and am not sure why there are 2 yellow ones connected to the same terminal. The wires are G, Rc, Rh, W, Y (2 yellow connected to this), and a blue one that isn't used. Help!

Thermostat Installation [ 2 Answers ]

I live in a Condo which has heating controlled by a boiler system which sends hot water through baseboards along the wall. I am trying to install a new thermostat because I think the previous owners installed an old, junky one right before they moved out and did it incorrectly. We now have...

Thermostat Installation [ 5 Answers ]

About to install a new Honeywell RTH6300B thermostat. I have 4 wires coming from the wall... green, white, red and blue. Old thermostat had connections for W, RH, B, RC, G, O, Y... (Old thermostat was White Rodgers model # 1F86-244.) New Honeywell RTH6300B thermostat has connections marked G, W,...

Thermostat Installation [ 3 Answers ]

I'm replacing my old heat pump thermostat(American Standard) with a Hunter Programmable Thermostat(Model 44360). I have seven wires coming in and they are all connected as follows: The white comes in and connects to a terminal labeled X2 and jumper goes up to the terminal labeled W. Green...

View more questions Search